by INbtwn

Retro Car Club.

Colourway
Black acoustic section with an emblem, set into a timber slat wall

A raised emblem for the bar.

The logo is laser-cut from MDF, then painted and installed. It is set into an acoustic section of the slatted wall, framed by an illuminated border.

  • Line

    One with the space

  • Type

    Wall

Close-up of a red emblem with raised white letters on black textile

Material and finish.

Materials and dimensions for this project. Acoustic performance in a space also depends on how it is installed.

  • Logo material

    Interior-grade MDF

  • Thickness

    3, 6 or 9 mm, as preferred

  • Cutting accuracy

    ± 0.1 mm

  • Smallest detail

    0.5 mm

  • Edges

    Laser-charred, dark brown to black

  • Maximum sheet size

    1200 × 900 mm

  • Use

    Dry interiors: MDF is not naturally water-resistant

How it is made: step by step, in our own studio.

  • 01Preparing the logo

    We turn the club's logo into a digital cutting file. We check every line so the laser can follow even the emblem's finest details cleanly.

  • 02Setting up the laser

    The MDF sheet lies flat on the laser bed. We adjust the focus to suit its thickness for a consistently clean cut.

  • 03Laser cutting

    The laser cuts out the logo layer by layer at a steady pace. This keeps the edges crisp and straight, even in small letters and curves.

  • 04Finishing by hand

    We clean each element, clearing even the smallest traces of waste from the fine details by hand. We then lightly sand the edges so the paint adheres well.

  • 05Painting and installing

    We apply the emblem’s colours in several coats. After a final check of the dimensions and finish, we install it in the acoustic section of the slatted wall, framed by an illuminated border.

A project like this, in your space?

Let’s talk about your space →More about One with the space →All projects →